![]() Hello, I found the below info. On another forum. One should be a NAT interface that it can use to access the Internet, and the other should be a host-only interface to enable it to communicate with the host machine. For example, your NAT interface could be eth0 and have a 10.x IP address, and your host-only interface could be eth1 and have a 192.168.x IP address. Hope it helps. I needed to figure out port forwarding as well.I did it.but havent tested it yet. My internet is still working after the changes though.so thats an improvement ------------------------------------------------ If you have Mac OS X 10.4, then I've found that the easiest way to set up port forwarding on the Airport Extreme/Express is to use a fixed IP address for your computer and use the NAT Port Mapping Protocol. First, ensure that your ADSL modem is not used as a router (many people have BOTH their router and Airport setup as a router. For example, both the Zoom 5660 and DSL 300T are ADSL modem /routers: ensure that they are set in to a mode such as 'bridge': essentially, this means that your Airport Express/Extreme RECEIVES the IP address that your ADSL provider gives you.) Then, to set up the Airport for port forwarding, do this: 1. Log into Airport Admin Utiity, and choose the Network tab. Choose Distribute IP addresses, and Share a SINGLE IP address. ![]() Enabling Ip Forwarding And Nat From Console For Mac DownloadRed alarm clock mac. Then choose use 172.16.1.1 addressing. Under the Airport tab, choose Base Station Options. Tick the following: Enable SNMP Access Enable Remote Configuration Enable Default Remote Host at 172.16.1.253 Enable NAT Port Mapping Protocol 3. Goto the Internet tab to make a note of the DNS servers (these are for your ADSL provider: they should be in grey to the right of the screen: if they are not, do not worry.) Save the configuration. Your internet connection won't work now: you need to give your computer the fixed IP address chosen above. ![]() To do this: 4. Goto System Preferences, Network, then TCP/IP. Your connection will probably be set up Automatically using DHCP. First, make a note of the Subnet Mask (will probably be 255.255.255.0) Then, change the Configure IPv4 tag to: Manually IP Address: 172.16.1.253 Subnet Mask: (whatever you noted above, eg: 255.255.255.0) Router: 172.16.1.1 (this is the Airport's IP Address) DNS Servers: your ADSL provider's servers (from part 3: if you do not have them, phone your ADSL provider, or try using: 4.2.2.1 and 4.2.2.2). Save the settings (Apply Now) then goto Show All and Sharing, then choose the Firewall tab. Ensure the Firewall is ON, then choose New. Enabling Ip Forwarding And Nat From Console For MacTo choose a new Port (eg: 9090). Update and restart your computer. Enabling Ip Forwarding And Nat From Console For Mac ProTransmission is great: on a 1MB connection, I'm consistently getting download speeds of 90-100K (as opposed to Aquisition's 20-30k). Keep up the good work!! Instead of creating a new thread, I thought I'd continue on this one. I'm having probs opening the Windows Sharing and/or the Personal File Sharing port on the new Airport Extreme router. Gihosoft android data recovery for mac.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |